Asign RS-Style Honeycomb Front Grille with Quattro Lower Mesh for Audi Q7 4M (2016–2019)

What Is It?

A complete replacement front grille with an RS-inspired honeycomb pattern and matching lower bumper mesh.

Who Is It For?

Owners of compatible Audi Q7 4M pre-facelift vehicles seeking a more aggressive, visually unified front end.

How Does It Install?

The original grille is removed and replaced. Front-bumper removal and professional installation are recommended.

What Must Be Checked?

Model year, 4M generation, bumper design, front camera, driver-assistance hardware and plate-mount requirements.

RS-Inspired Honeycomb Pattern

The open honeycomb layout replaces the factory horizontal-grille appearance with a more performance-focused front-end design.

Matching Quattro Lower Mesh

Coordinated lower mesh extends the honeycomb styling across the lower bumper instead of leaving the upper and lower sections visually mismatched.

Two Outer-Frame Finishes

Choose a gloss black frame for a darker blackout appearance or a chrome frame for stronger contrast around the grille perimeter.

Selectable Front Ring Finish

Pair the grille with either a chrome or black front ring emblem to coordinate with the exterior trim and overall styling direction.

Optional Plate-Free Appearance

The supplied front plate bracket does not need to be installed where local regulations and the selected grille configuration permit.

Factory Hardware Retained

Compatible original camera, sensor and electronic components remain with the vehicle and are transferred during installation where applicable.

Provide These Vehicle Details

• Vehicle year and model
• 4M generation confirmation
• Clear full front-view vehicle photo
• Close-up photo of the original grille
• Whether the vehicle has a front camera
• Whether driver-assistance hardware is installed behind the grille
• Preferred front plate-mount configuration

Why This Check Matters

• Grille mounting points differ between generations and facelifts.
• Camera and driver-assistance layouts may require different brackets.
• Aftermarket bumpers may not retain factory grille dimensions.
• North American and international vehicle specifications may differ.
• A model year alone cannot confirm every front-end configuration.

Standard Plate Bracket

A 53 × 13 cm front license plate bracket is supplied by default. This is a European-format size and may not directly match standard North American license plate dimensions.

Alternative Configuration

Contact Asign before ordering when a different plate-mount or no-pre-drilled-hole configuration is required. Custom processing may extend preparation time by approximately five days.

Inspect the New Components

Verify the grille finish, ring emblem finish, lower mesh, plate bracket and applicable camera hardware before disassembling the vehicle.

Protect the Front-End Surfaces

Protect the headlights, fenders and painted bumper edges before removing fasteners or surrounding trim.

Remove the Front Bumper

Remove the bumper and disconnect applicable factory wiring or hardware according to the vehicle service procedure.

Transfer Compatible Hardware

Transfer retained factory brackets, cameras, sensors or wiring only where they are compatible with the new grille configuration.

Install and Align the Grille

Position the main grille and matching lower mesh, then verify perimeter alignment and secure all accessible mounting points.

Test Before Final Assembly

Test cameras, parking assistance and related systems before completing the bumper reinstallation.

Not Included

• Front bumper assembly
• Factory camera, radar or parking sensors
• Factory wiring or electronic control modules
• Driver-assistance calibration
• Installation tools or labor
• RS-style badge shown for display unless specifically confirmed in the order